27
When a continuous series of beeps sounds, all the lights
turn off on
the control panel and a number appears on the
display, a fault has
occurred.
The dryer will automatically
enter this mode if a fault occurs. The word ‘Fault’ will be
shown in the control panel display followed by a number,
refer to example. To stop the beeps, touch any button then
perform the following steps:
1
Turn your machine off at the power point.
2
Wait one minute and turn it back on.
3
Check your machine is installed correctly
(refer to ‘Installation instructions’ section).
4
Remove your load from the dryer and retry.
5
Perform a ‘Time Dry’ cycle, eg Time Dry for 30 minutes.
6
If the fault re-occurs repeat steps
1
and
2
.
7
If the machine still will not work call a Fisher & Paykel
trained and supported service technician to arrange service
(refer to ‘Customer care’ section). Record the fault code
number displayed and the serial number of your dryer
(located on the rear of the machine, or on the inside of the
door below the glass) before calling. The fault code will
indicate to the service technician what the problem could
potentially be.
If a fault code is being displayed, you can still turn your dryer off by pressing ‘POWER’.
FAULT CODES
FAULT
E2
Contact the F&P
Customer Care Centre
Time Dry
Set Time
30min
Содержание DH8060C
Страница 1: ...INSTALLATION GUIDE USER GUIDE NZ AU HEAT PUMP CLOTHES DRYER DH8060C DH9060C models ...
Страница 2: ......
Страница 4: ......