Fisher & Paykel DH8060C, Инструкция по установке/Руководство пользователя

Страница: 27 / 40

25
Emptying the water collection tank
During the drying cycle, steam condenses into water
and is collected in the water tank, located at the top
left of the dryer. It is important to empty the water
tank after every load.
If the water tank becomes full during operation,
the dryer will pause, display a user prompt and beep
to alert you. You must empty the tank before the
dryer can continue drying. Empty the tank, replace it
in the housing then touch
to resume the cycle.
Note: You do not need to empty the water tank
if you have set up the drain hose to drain the
water automatically.
To empty the water tank:
1
Remove the water tank by holding onto the
handle and pulling outwards gently to remove it.
Ensure that you keep the tank level when it is being
removed to prevent the water collected from spilling.
2
Pour the water down the sink or into a bucket,
and then put the tank back in place.
IMPORTANT!
● ●
Do not use the water collected in the water tank for
drinking or food processing.
● ●
Never run the dryer without the water tank in place unless
the drain hose has been installed.
Cleaning the sensors
There are sensors in your dryer that detect whether the laundry is dry or not.
These sensors need to be cleaned periodically (we recommend approximately
four times a year).
To clean the sensors:
1
Open the door of your machine.
2
Allow the machine to cool if drying has been
carried out.
3
Locate the metal sensors just behind the lint filter.
4
Wipe the sensors with a soft cloth, dampened
with vinegar.
Dry the sensors with a soft dry cloth.
CARING FOR YOUR DRYER
Location of the sensors
Removing the
water collection tank
Tipping out the water
from the condensing tank