Fisher & Paykel 93275, Инструкция по установке/Руководство пользователя

Страница: 30 / 82

26
DRYING CYCLE OPTIONS
Delay Start
The ‘Delay Start’ option enables you to delay the start of the drying cycle from between
5 minutes and 12 hours. Times you can select are 5 min, 15 min, 30 min, 1 hour, then
hourly up to 12 hours. This can be useful to time your drying to finish when you arrive
home from work, or to start when power rates are lower.
To programme a ‘Delay Start’, simply touch the ‘More’ button to increase the delay
time and ‘Less’ button to decrease the time or to turn ‘Delay Start’ off. Touch
to confirm your selection and start the countdown. Once the ‘Delay Start’ has been
started, the time will count down on the digital display in one minute increments,
the ‘Delay Start’ light will flash and the light will stop flashing and remain lit.
The ‘Delay Start’ option is not available on ‘Time Dry’ or ‘Rack Dry’.
We suggest that you avoid using ‘Delay Start’ for damp, non-colourfast items
as this may cause dye run to occur.
Customising dryer cycles
After using your dryer a few times you may discover there are some drying options you
prefer for some cycles.
You can programme your dryer to remember the drying options you prefer for each
drying cycle. For instance, you may want to set the ‘Easy Iron’ cycle to a lower drying
temperature or set the ‘Everyday’ cycle so it automatically has the ‘Wrinkle Free’
option selected.
To customise a cycle:
1
Press ‘Power’ to turn the dryer on.
2
Turn to select the cycle you wish to customise.
3
Touch and hold any of the drying options buttons for 3 seconds.
The lights will flash on and off and the display will show to indicate
that the dryer is in cycle adjustment mode.
4
Select the drying options you prefer by touching the relevant option button.
5
Touch and hold for 3 seconds to save the selected settings.
The dryer will then beep to indicate your customised cycle has been saved.
Factory reset
You can reset your dryer to the default settings it left the factory with:
1
Select the ‘Freshen’ cycle.
2
Touch and hold the ‘Delay Start’, ‘More’ , the ‘Delay Start’, ‘Less’ and ‘Signal’ buttons
together for three seconds.
3
Your dryer will now be reset to the default settings.