FISCHER FISCHERSCOPE X-RAY 5000 Series, Руководство оператора

Страница: 82 / 188

Task programming Example Specification Limit Commands
82 FISCHERSCOPE
®
X-RAY
?KX minimum 1 reading is not measurable
(in the following sub-chapter, the commands of S are explained
using a practical example)
11.6 Example Specification Limit Commands
The following example clarifies the terms used on the previous
pages at “S”:
Task:
The values of the “current measurement data set” in the three-line
table shown below are sought.
The “current measurement data set” shall be the numeric set
printed in italics; it is the measurement data set of the last previous
measurement. In our example, it is the number set in the third line
(with “n = 3”).
The placeholder i (i=1,2,3) is the counter for the place number in
the line from left to right of the measured element within the current
measurement data set.
!
Caution
The placeholder i does not stand for the consecutive number of
the measurement data set within the test series!
(Note: correctly, this would be the designation n)
i=1 i=2 i=3
n = 1 Cr = 0.70 μ m Ni = 4.09 μ m Cu = 6.17 μ m
n = 2 Cr = 0.73 μ m Ni = 4.12 μ m Cu = 6.27 μ m
n = 3 Cr = 0.78 μ m Ni = 4.21 μ m Cu = 6.20 μ m
Solution: The values below from the third line (where n=3) were
sought:
Here, reading 1 is the reading for Cr, i.e., 0.78 μ m
Reading 2 is the reading for Ni, i.e., 4.21 μ m
Reading 3 is the reading for Cu, i.e., 6.20 μ m