Fischer Panda Panda AGT 6000, Руководство пользователя

Страница: 164 / 192

VCS-AGT-U/I
Seite/Page 164 - Kaptitel/Chapter 10: VCS-AGT-U/I 9.12.14
10.4.2 Checking of the VCS voltage control when the generator is not running
Requirements: 1. VCS-cable connected?
2. Cable for measuring voltage connected to the VCS?
3. Cable for current measuring input connected to the VCS?
4. Actuator spindle lubricated with anti-seize?
Fig. 10.4.2-1: Clamp 50 Checking the actuator
1. Disconnect clamp 50 at the starter
2. Switch the remote control panel on and press the start
button.
As long as the relay of the starter is controlled, the VCS
regulates the accelerator in the maximum position (over the
starter motor). When the start relay is not active, the
accelerator goes to zero (over the actuator).
Check the right working of the actuator.
10.4.3 Function of the VCS
The current regulation barrier can be finely adjusted over a potentiometer, which is accessible at the back of the
VCS (+5 % / -24 %).
10.4.4 Checking the VCS voltage regulation
Connect clamp 50 to the starter motor again and start the generator. Control the battery voltage and check if the
generator regulates the voltage. Check, if the generator regulates the voltage exactly by switching on and off load.
Fig. 10.4.4-1: Potentiometer charging voltage Readout potentiometer for the charging voltage
1. Potentiometer for setting the charging voltage
Turn to the right for increasing the charging voltage.
1