Fischer Panda 5000i PVK-U, Руководство пользователя

Страница: 64 / 174

Installation Instructions
Seite/Page 64 Kapitel/Chapter 6: Installation Instructions 30.10.12
6.5.4 Position of the pre-filter with water separator
Fig. 6.5.4-1: Pre-filter with water separator
Additionally to the standard fine filter a pre-filter with water
separator must be installed outside of the sound insulation
capsule in the fuel system line (not included in the delivery).
representative picture
6.6 Generator DC system installation
The Panda generators from 6000 upwards have their own dynamo to charge a DC starter battery.
It is recommended to install an additional starter battery for the generator.
The generator is then independent from the remaining battery set. This enables you to start the genset at any time
with its own starter battery even if the other batteries are discharged. A further advantage of a separate starter
battery is that it isolates the generator's electric system from the rest of the boat's DC system, i.e. minus pole (-) is
not connected electrically to Earth/Ground.
The generator is then Earth/Ground free.
6.6.1 Connection of the starter battery block
I An own separate starter battery must be installed for the generator.
The positive cable (+) of the battery is attached directly at the solenoid switch of the starter motor (position 1). The
negative cable (-) of the battery is attached underneath the starter motor at the engine mount (position 2).
NOTE: Panda Generators Panda 6000 and higher normally
provided with an alternator/dynamo to charge the starter
battery. At generators without alternator/dynamo it is
needed to charge the starter battery with an external
battery charger.
ATTENTION! Make sure that the voltage of the starter battery fits to
the start system voltage
f.e. 12 V starter battery for a 12 V start system
f.e. 24 V starter battery for a 24 V start system (2x12 V
batteries in a row)