Fischer Panda 4000s PMS FC, Руководство пользователя

Страница: 123 / 140

Tables
26.1.11 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 8: Tables Seite/Page 121
8. Tables
8.1 Troubleshooting
GENERATOR OUTPUT VOLTAGE TOO LOW
For 60Hz versions: less than 100V
Cause Solution
Generator is overloaded. Reduce the electrical load. (Switch off load)
Motor is not reaching the rated rpm. Refer to "motor faults" section.
Defective capacitor(s). Check capacitors and replace if necessary.
GENERATOR VOLTAGE TOO HIGH (MORE THAN 135V-60Hz)
If the generator is providing excessively high voltage, the following potential causes should be investigated:
Cause Solution
Over-energizing due to wrong capacitors. Check capacitors type and replace if necessary.
GENERATOR VOLTAGE FLUCTUATES
Cause Solution
1. Disturbances on the electrical system/user side.
2. Motor disturbances.
1. Check if electrical load is fluctuating.
2. Refer to section: "Motor runs irregular".
GENERATOR NOT ABLE TO START ELECTRIC MOTOR
Cause Solution
If the generator is unable supply enough power to start
an electric motor, it is usually because the motor draws
too much current during starting process. Check the motor's current draw required for starting
Enquire at your nearest Panda dealer or directly at the
manufacturer.
DIESEL MOTOR FAILS TO START
Cause Solution
Starter battery switched "OFF". Check position of battery switch and switch "ON" (if
installed).
Starter battery voltage insufficient (battery too weak). Inspect battery terminals and cables for a good electrical
connection (Inspect against corrosion, tattered wires,
etc.).
Starting current disrupted. During the normal starting process, the battery voltage
drops to 11V with a fully charged battery. If the voltage
does not drop during starting, the electrical connection is
faulty. If the battery voltage drops lower than 11V, then
the battery has been discharged.