Fischer Panda 15000i PMS, Руководство пользователя

Страница: 123 / 176

Inverter Panda PMGi
4.5.16 Kapitel/Chapter 10: Inverter Panda PMGi - Seite/Page 123
10.11Installation of the PMGi
The PMGi must be mounted vertical, with the electrical connection down. So you can read the writing on the PMGi.
The surface where the PMGi is mounted should be smoothed and support the heat transfer. The Air holes and Air
grille must be not covered and enough cooling air must be pleasant at any time for the PMGi.
To mount the PMGi use the fixing holes diameter 6,5mm.
Note! See the safety instruction in your Generator and iControl
Manual.
The rules of the respective regional authority must be adhered to. Only an electrician may carry out installation of the
electrical connections for safety reasons.
10.11.1 Cooling water connection schema - Vehicle Generator
10.11.1.1 Integration of a water cooled PMGi inverter into the cooling system.
The water cooled PMGi needs a separate cooling circle. Normal a small radiator net is attached to the bigger
Generator Radiator. The circle has its own electrical water pump, which is powered by the generator.