Fischer Panda 10000/9, Руководство пользователя

Страница: 66 / 246

Installation Instructions
Seite/Page 66 - Kaptitel/Chapter 7: Installation Instructions 9.12.14
Fig. 7.4.2-1: Position of the Through Hull Fitting For Panda generators, the through hull inlet should NOT
point in the sailing direction! When sailing at higher
speeds more water will be forced into the inlet than the
pump can handle and your generator will flood!
7.4.3 Quality of the Raw Water Sucking In Line
In order to keep the suction resistance in the line at a minimum, the raw water intake system (i.e. sea cock, through-
hull fitting, inlet filter, etc.) must have an inner diameter of at least 1" (25 mm).
This applies also to installation components such as through-hull fitting, sea cock, raw water filter etc.
The intake suction line should be kept as short as possible. Install the raw water inlet in close proximity to the
genset.
After start-up the cooling water quantity must be measured (e.g. by catching at the exhaust). The flow rate,
as well as the necessary cross section of the cooling water pipe see section 11.10, “Diameter of conduits,”
on page 219