![Fischer Panda 0014668 Скачать руководство пользователя страница 76](http://html.mh-extra.com/html/fischer-panda/0014668/0014668_manual_2294271076.webp)
Maintenance Instructions
Seite/Page 76 - Kaptitel/Chapter 6: Maintenance Instructions
23.3.18
Fill the engine oil into the engine via feed hopper. Check oil-level after every 0,75 litres with the oil dipstick.
9. Check proper filling level. See section 6.7, “Checking oil-level,” on page 72.
When the proper filling level is reached, screw in the oil cap again. Run the engine for 10 minutes and then turn it
off. Check the oil-level once more after several minutes with the oil dipstick. If it is too low, refill some oil.
10. Clean up
Wipe off all oil splashes from the generator and make sure that the drain screw has no leak.
6.8.1 After the oil change
• Screw the oil dipstick back into the check rail.
• Close the oil filling cap.
• Remove potential oil stains and splashes from the generator and surroundings.
• Close the generator casing.
• Remove lock against accidental generator start.
• Duly dispose of used oil and filter.
Used oil is very toxic and must not be disposed with domestic waste. It is prohibited to dispose used oil with
waste water! Make sure that used oil is disposed properly (e.g.: where oil is bought or at collection stations).
6.9
Verifying the starter battery and (if necessary) the battery bank
Check the condition of the battery. Proceed here as prescribed by the battery manufacturer.
If from the battery manufacturer not otherwise mentioned.
6.9.1 Check battery and cable connections
Fig. 6.9.1-1: Battery
• Keep battery clean and dry.
• Remove dirty clamps.
• Clean terminal posts (+ and -) and clamps of the battery,
and grease with acid-free and acid-resistant grease.
• When reassembling, ensure that clamps make good
contact. Tighten clamp bolts hand-tight.