Firetide HotPort 5020, Руководство по установке

Страница: 24 / 47

16
Outdoor node installation
Preparing a node for outdoor installation
It is easier to install all devices to one object, such as a pole, and then attach the
pole assembly to the roof. If you attach the devices to a pole attached to the roof
top, factors, such as weather, can make the installation more difficult and
dangerous.
Warning!
Only use antennas that are rated for outdoor applications.
W
arning!
Failure to obey these instructions might result in severe
personal injury including electrical shock or permanent damage to
equipment.
Warning!
Make sure that all safety equipment is in good condition. Do
not use broken or damaged tools or equipment. Always use safe work
practices and obey all local and national guidance for earth ground
requirements and electricity.
Note:
Collect all tools before you install nodes.
To prepare a node for outdoor installation:
1.
Make sure that you have antennas rated for outdoor use. For information
about antennas and how to select them, see the
Firetide Antenna and
Accessory Guide
.
Note:
Install the antenna and any other wireless devices higher than the HotPort
node or access point.
2. Remove the mount bracket from the node.
a. Use the Phillips screwdriver to loosen the four captive screws (two
on each side).
Captive screws
b. Remove the outer piece from the hooks on the node.