1
CM-64
64 Channel Command Module
CM-64 Panel Diagram
Power Button
This turns the Command Module
(CM) on. Press and hold this
button to power on the CM. Hold
the button until the internal lights
come on (about 3 seconds). If the
CM does not power on, plug in
the charging cord into the
charging port (Please wait 1
minute for the power to be ready
once plugged in). To turn the
power off, simply press and
release the button.
Arm Key
This is a key slot. Insert the key
and turn it clockwise then press
the ARM/SAFE button. Turning
the key counterclockwise will
disarm the system. The key must
turn from SAFE to ARM, it cannot
be left in the ARM state. The key
cannot be removed when in the ARM
position.
Fire Button
In Manual Channel Fire mode, pressing the fire button will fire the next firing channel on the
selected module. The fire button can also be used to start the time code in an Internal clock
show. It is also used to enable the firing of a SMPTE show. See the details below on each show
type for details.
Charge LEDs
These LEDs indicate the power status of the CM. The red LED indicates that the battery charger
is plugged in and providing power. The green LED indicates that the battery is fully charged.
Control Buttons
These buttons are used to select which screen the CM will display. These are the Home, Menu,
Continuity, Wireless Wizard, Module Status, Show, and OPN Interface screens. It also has the
ARM/SAFE button, which is used with the Arm key to arm the system.
Figure 1
