21
Woodtec Freestanding
Issue 01.1 05/17
8.0
Maintenance Guide
8.1
Removal of or Inspection above Baffle Plate. 1. First lift upwards at the front and
at the same time sliding the rear forwards off the back baffle support bracket. 2.
Next lower the rear edge into the firebox and allow the front of the baffle to slide
off the front baffle support brackets. 3. Finally rotate the baffle and lift out out of
the firebox.
8.2
Removing Firebox Liners 1. First bring the front edges of the left and right firebox
liners inwards at the front as you slide them forwards until they disengage from
the rear liner. Unscrew and remove the baffle support brackets to assist if
required. Then tilt them slightly and remove from the firebox – NOTE: Ensure
that the rear firebox liner does not fall forwards and break! 2. Remove the rear
firebox liner being very careful not to damage the profiling at the top which is
delicate.
8.3
Removing firebox base components. Remove the firebox liners as above. Now
gently lift up and rotate the base ceramic piece slightly to lift it out through the
firebox front opening.
8.4
Removing Flue Spigot Collar. Unscrew
4 x M6 securing screws from inside the
firebox and remove spigot collar. When
re-assembling either use a suitable
fireproof gasket or fire cement.
