Fiori E81 AQUA, Руководство пользователя

Страница: 5 / 8

5
If the hood fails to operate correctly, briefly
disconnect it from the mains power supply for
almost 5 sec. by pulling out the plug. Then plug it
in again and try once more before contacting the
Technical Assistance Service.
Warning!
— The hood cannot be connected to flues of
other appliances that run on energy sources
other than electricity.
— When the hood is used at the same time of
other appliances that run on energy sources
other than electricity, provision must be made
for an adequate supply of air.
— No food must be cooked flambeé underneath
the hood.
The use of an unprotected flame is dangerous
for the filters and could cause fires.
Therefore, never use an open flame under the
hood. When frying foods, never leave the pan
alone because the cooking oil could flare up.
— Please, keep to the provisions of official
directives regarding the question of fume
discharge.
— The manufacturers refuse to accept any
responsibility for damage to the hood or its
catching on fire because of failure to observe
the above instructions.
Maintenance
Before performing any maintenance operation,
isolate the hood from the electrical supply by
switching off at the connector and removing the
connector fuse.
Or if the appliance has been connected through
a plug and socket, then the plug must be removed
from the socket.
Metal grease filter (2 or 3 pieces)
The metal grease filter lasts forever and must be
washed either by hand or in the dishwasher
(65°C)
with suitable detergents.
The metal grease filters must be washed at least
once a month and anyhow whenever
LED 4
indicates the saturation of the filter.
This LED warns you when the metal grease filter
needs to be cleaned.
This LED flashes to warn you that the metal
grease filters must be cleaned.
Generally, these must be cleaned after 40 hours
of use.
Once the grease filters have been cleaned, press
button 1 for some seconds until you hear the
acoustic signal (beep): the LED 4 will now stop
flashing.
When washed in a dish washer, the grease filter
may discolor slightly, but this does not affect its
filtering capacity.
Remove the filter using the handles designed
for this purpose by pulling the filter backwards
and then downwards (Fig. 1).
Let the filter dry without damaging it before putting
it back into place.
Carry out the above steps in reverse order to put
the filters back after having washed them.
Carbon filter (2 pieces)
This filter dissolves cooking odors.
The carbon filter must never be washed.
The carbon filter should be replaced every 4
months under normal use and anyhow whenever
LED 5 indicates the saturation of the filter.
This LED indicates carbon filter needs to be
replaced.
This led flashes to warn you that the carbon filter
must be replaced.
This must be done after approximately 160 hours
of use.
Once you have replaced the carbon filter, press
button 1 for about 3 seconds until you hear the
acoustic signal (beep).
The LED 5 will now stop flashing.
Using the hood—
The hood is provided with a motor with severa l speeds.
For the best performance,we recommend using
the low speeds in normal conditions and the high
speeds in particular cases of strong odour and
vapor concentration.—We recommend starting
up the hood a few minutes before cooking and
keeping it running until all the odors have been eliminated.