Page 1
INSTRUCTION MANUAL
www.fimcoindustries.com
1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049
Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440
[5195302
(09/19)]
Important safety instructions for Volt Edge Wireless Remote.
Save these instructions: This manual contains important safety instructions for Volt Edge wireless remote.
This remote is only compatible with Volt Edge products.
Warning:
Shock hazard. Do not allow any liquid to get inside remote.
Button Identification
The small LED at the top of remote turns red when transmitting.
The red LED is also the pairing button.
The ‘ON’ button will only turn on the Volt Edge Receiver.
The ‘OFF’ button will only turn off the Volt Edge Receiver.
Pairing Procedure:
1.
Ensure the receiver power cord is not connected.
2.
Install a charged battery pack into the receiver.
3.
Power ON the Volt Edge receiver. Within 15 seconds press and hold the pairing button for 5 seconds. The green LED on the receiver will
quickly turn off and back on when pairing is successful.
4.
Power OFF the Volt Edge receiver.
5.
Power ON the Volt Edge receiver and press the OFF and then ON button to confirm pairing is successful.
Storage Recommendations:
The best storage place is one that is cool and dry, away from direct sunlight and excess heat, cold or moisture.
Remote Capabilities:
The remote can control the receiver up to 50 feet away. Obstructions
and radio interference can reduce the effective distance.
A remote can be paired to multiple receivers at a time.
A receiver can only be paired to one remote at a time.
Retain a copy of receipt for your Fimco Product.
As it will be required to validate any warranty service.
Volt Edge products are warranted against manufac-
turer or workmanship defects for One (1) year from
date of purchase for home owner usage and 90 days
for commercial usage.
Wireless Remote
(5164291)
Problem
Possible Cause
Possible Solution
Remote battery
is discharged
Replace the battery with
CR2032 size button cell battery
Receiver
is not on
The green light must be illuminated on the
receiver for the remote to control it
Remote is not
paired with
receiver
Follow the Pairing Instructions to pair a
remote and receiver
Radio
Interference
Move the receiver and remote away from
the electronic interference
TROUBLESHOOTING
Remote
does not
control the
receiver
