Page 1
OWNER’S MANUAL
www.fimcoindustries.com
1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049
Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440
[5194681
(09/18)]
Installation and Service Information
Fimco High-Flo High Performance pumps are designed to pump water and aqueous solutions of common pesticides. They are not
designed to pump petroleum products or other flammable materials. They are not designed to pump bleach solutions.
Use of this
pump for petroleum products or bleach solutions will void the warranty.
When pumping liquids other than water, the pump
should be flushed out with a cleaning solution, such as Fimco Tank Neutralizer & Cleaner, or clean water mixed with a good grade
dish soap after each use to prolong pump life.
This High-Flo High Performance pump is equipped with a demand switch that reacts to outlet pressure and shuts the pump motor off
at a factory set pressure limit of 60 PSI. When the pressure drops below this preset limit the switch allows the pump motor to start
again.
High-Flo High Performance pumps are self-priming. Vertical prime will depend on the viscosity of the liquid and suction line size. Mini-
mum recommended suction line size is 3/8 inch. All hose connections need to be tight or air leakage will break the prime and disrupt
water flow. The installation of a 50 mesh strainer is recommended to prevent debris or other foreign material from entering the pump
and causing pump failure. The pump should be mounted in a dry and adequately ventilated area. The pump can be mounted horizon-
tally or vertically. If mounted vertically, the pump head should be down and the motor should be up. Your pump will come with adapt-
ers which will allow you to hook up to various plumbing configurations. These fittings push into the ports of the pump and a slide
mechanism ‘locks’ them into place. Use flexible hose or tubing to connect to the inlet and outlet ports on the pump. This minimizes
stress on the pump head. Never use rigid pipe connections. Do not compress the feet. Overtightening will reduce the ability to isolate
vibration & noise.
Your pump is rated at 2.4 GPM @ open flow. If the discharge plumbing is very restrictive or nozzle tips are undersized, the back pres-
sure will cause the pump to cycle rapidly. This rapid cycling will increase the operating temperature of the motor and the amperage
draw on the power supply. Extended use with this cycling will cause premature failure of the pump.
Your pump is designed to run off of the battery of your ATV, lawn tractor, or other vehicle with a 12V system. If using a stand alone
battery, use a deep cycle RV or marine battery.
The pump should be winterized before storage, by pumping a solution of RV antifreeze through it, and the entire plumbing system.
12 Volt, 2.4 GPM, 60 PSI
Diaphragm Pump
Model: HFP-24060-113
(5281371/5151087)
Retain a copy of receipt for your pump.
As it will be required to validate any warranty service.
High-Flo High Performance Pumps are warranted
against manufacturer or workmanship defects for
Two (2) years from date of purchase for home owner
usage and 90 days for commercial usage.
See Page 4 for Warranty Information
