N.B.:
at the end of the countdown you return to the working screen that was previously used and the pressure on the brush head goes
back to standard.
2
3
2
3
Back
0000.00
100%
POWER
0000.00
100%
1
4
WORKING HEADLIGHTS
The machine is equipped with front and rear working lights. To start them do as follows.
1. With the machine on, press the menu button (1) on the working screen (
Fig.1
).
2. Press the working lights activation - deactivation button (2) (
Fig.2
).
N.B.:
if the symbol (2) is grey the working lights are not active, if the symbol (2) is green the working
lights are active.
N.B.:
to quit the menu screen, wait a short time without pressing anything, or else press on any point
of the display (except one of the displayed buttons).
N.B.:
the sidelights come on when the machine is started.
N.B.:
if the side lights are activated the relative symbol (3) is displayed.
N.B.:
if you want to switch off the lights press the button (2).
N.B.:
to return to the working screen press on any point of the screen, except the edges of the display or else wait three seconds without
touching anything.
OFFICE
0000.00
100%
ECO mode
0000.00
100%
1
2
2
1
3
EMERGENCY BUTTON
If any problems are encountered during the work operations, press the emergency button (1) on the electrical system's cover carter (
Fig.1
).
CAUTION:
This command interrupts the electrical circuit between the batteries and the machine system.
N.B.:
After having stopped and resolved the problem, the work operations can be resumed by doing the following:
1. Bring the main switch to its "0" position by turning the key (2) a quarter turn anti-clockwise (
Fig.2
).
2. Disengage the mushroom-head emergency button (1) (
Fig.3
).
3. Set the main switch to "I" by turning the key (2) a quarter turn clockwise.
1
3
1
1
2
2
BRAKING CONTROL
The machine has an encoder to help braking and also a mechanical brake. If the machine is moving and the accelerator
pedal is released, the machine brakes with a gentle deceleration ramp, until it stops the encoder. Only when the
encoder has stopped is the electric brake engaged. If the machine is moving and the brake pedal (1) (
Fig.1
) is pressed,
the machine brakes according to braking force of the mechanical system. Only when the encoder has stopped is the
electric brake engaged.
1
1
28
