Fimap MAGNA PLUS, Руководство по эксплуатации и обслуживанию

Страница: 20 / 48

12. Make sure the water system filter cap (7) is closed. If it isn't, close it (
Fig.7
).
N.B.: For the sweeping versions, the water system filter is located on the right of the machine.
13. Close the left side casing of the machine.
14. Check that the water tap is fully open, move the water adjustment knob (8) in the direction shown by the arrow (
Fig.8
).
15. Stand at the back of the machine.
16. Check that the solution tank drainage cap (9) is closed. If this is not the case, close it ( Fig.9 ).
17. Make sure the cap of the recovery tank drainage tube (10) is closed. If it isn't, close it ( Fig.10 ).
18. Make sure the vacuum tube (11) is correctly connected to the sleeve in the squeegee body. If it isn't, connect it ( Fig.11 ).
19. Grip the handle (12) and raise the recovery tank's lid to its maintenance position (
Fig.12
).
ATTENTION: to prevent the cover from rotating, insert the pin (13) into the support (14) ( Fig.13 ).
20. Make sure the suction motor filter (15) is correctly connected and is clean ( Fig.14 ). If it isn't, clean it (see “ CLEANING THE RECOVERY
TANK FILTERS ”).
21. Make sure the vacuum duct filter (16) is correctly connected and is clean ( Fig.15 ). If it isn't, clean it (see “ CLEANING THE RECOVERY
TANK FILTERS ”).
22. Make sure the filter-strainer (17) is correctly connected and is clean ( Fig.16 ). If it isn't, clean it (see “ CLEANING THE RECOVERY TANK
FILTERS ”).
STARTING WORK
The machine can be used in the following work modes:
• ECO-MODE, read the section “ ECO-MODE ”;
• MANUAL MODE, read the section “ MANUAL MODE ”,
• PROGRAM ZONE, read the section “ PROGRAM ZONE MODE ”.
As an example, we will look at the program mode. To begin working in this mode, proceed as follows:
1. Make all the checks listed in “ PREPARING TO WORK ”.
2. Sit on the driver’s seat.
3. Insert the key (1) into the main switch on the control panel. Set the main switch to "I" ( Fig.1 ).
4. The first and second screen displayed allow you to check the software versions of the functions board and the display board.
5. A few seconds after turning on, the “MAIN” screen will appear (
Fig.2
).
N.B.: by default the machine is set to the transfer program ( Fig.2 ).
6. Select the desired working program with the DS selector device (see “ DS (DRIVE SELECT) SELECTOR ”).
7. Select the required work area and press the “ZONE” key (see “ ZONE PROGRAM MODE ”).
8. If a working program is selected which includes “SCRUBBING WITH DRYING”, open the flow of the detergent solution into the machine's
water system and shift the knob (2) upwards ( Fig. 3 ).
9. Press the drive pedal (3) to begin moving the machine ( Fig.4 ).
If the program selected is “SCRUBBING WITH DRYING”, the squeegee and brush head will lower until they touch the floor. As soon as the
drive pedal is pressed, the traction motor, brush head motor and vacuum motor will start working. As a result, the solenoid valve will also be
activated and detergent solution will be dispensed onto the brushes. During the first few metres, check that there is sufficient solution and that
the squeegee is drying correctly. The machine will now begin to work with full efficiency until the battery is flat or until the detergent solution has
finished.
1
DRIVE
0000.00 100%
2
1
4 3
2
3
20