HOW TO UNPACK THE MACHINE
The machine is shipped in specific packaging. To remove it, proceed as follows:
1.
Place the lower part of the outer packaging in contact with the floor.
N.B.:
use the pictograms printed on the box as a reference.
2. Remove the outer package.
WARNING:
the machine is contained in specific packaging materials, whose elements (plastic bags, staples, etc.) can pose potential
hazards, and must not be left within reach of children, disabled persons, etc.
3. Remove the boxes containing the disc brushes and squeegee body from the machine.
CAUTION:
these operations must be carried out using protective gloves to avoid any possible contact with the edges or tips of metal
objects.
4. At the rear of the machine position the three ramps present in the package.
ATTENTION:
the three ramps should be positioned so they are centred with the wheels of the machine, so that the machine is not
damaged during its descent.
5.
The machine is fixed to the pallet with wedges (1) that block the wheels (
Fig.1
). Remove these wedges.
6. Check that the main switch on the control panel has been set to “0”. If this is not the case, turn the key (2) a quarter turn anti-clockwise
(
Fig.2
). Remove the key from the main switch.
7. Grip the back of the seat (3) and turn the seat support plate to its maintenance position (
Fig.3
).
ATTENTION:
to prevent the seat from rotating, insert the retainer (4) into the slot (5) (
Fig.4
).
8. Connect the backup battery carriage's connector to the machine's main system connector (
Fig.5
).
9. Grip the back of the seat (3) and turn the seat support plate to the working position.
N.B.:
before rotating the seat support plate, remove the retainer (4).
10. Sit on the driver’s seat.
11. Insert the key (2) into the main switch on the control panel. Set the main switch to “I”, turn the key a quarter turn clockwise (
Fig.6
).
12. Using the DS selector on the command display (
Fig.7
), activate the “transfer” program (6) (see “
N.B.:
the grey symbols show working programs that are not active. the green symbols show working programs that are active.
13. Engage the reverse gear using the reverse gear activation/deactivation lever (7) (
Fig.8
).
14. Press the drive pedal (8) (
Fig.9
) to begin moving the machine.
15. Drive the machine down the ramp.
ATTENTION:
during this operation, check there are no people or objects near the machine.
16. Set the main machine switch to “0” (
Fig.2
). Remove the key from the main switch.
17.
Get off the machine.
CAUTION:
when getting down from the machine, do not place your foot on the scrubbing brush head or side brush head brush.
18. Grip the back of the seat (3) and turn the seat support plate to the maintenance position.
19. Grip the handle (4) and lift the recovery tank to its maintenance position.
20. Disconnect the backup battery carriage connector from the main machine system connector.
12
9
8
8
7
6
2
4
4
5
5
2
3
1
1
2
3
DRIVE
0000.00
100%
7
6
