AUTOMATIC DETERGENT DOSING SYSTEM (FSS PRO VERSIONS)
Upon request, the machine can be fitted with a system that measures out the detergent separately from the water in the
solution tank. To activate it, with the machine running, press the FSS SYSTEM ACTIVATION/DEACTIVATION button (1)
(
Fig.1
).
N.B.:
if the LED on the button (1) is on, the FSS system is active; if the LED is off, the FSS system is deactivated.
N.B.:
the FSS system activates when the electric pump in the machine's water system starts.
N.B.:
if you want to deactivate the FSS system press button (1) again.
N.B.:
the amount of detergent present in the washing solution dispensed by the machine is proportional (in a percentage defined by a
pre-set parameter in the machine) to the water flow rate present in the water circuit of the machine.
1
1
AUTOMATIC DETERGENT DOSING SYSTEM (FSS PLUS VERSIONS)
Upon request, the machine can be fitted with a system that measures out the detergent separately from
the water in the solution tank. To activate it, proceed as follows:
1. With the machine on, press the menu button (1) on the working screen (
Fig.1
).
2. Press the FSS system activation/deactivation button (2) (
Fig.2
).
N.B.:
if the symbol (2) is grey the FSS system is not active, if the symbol (2) is green the FSS
system is active.
N.B.:
to quit the menu screen, wait a short time without pressing anything, or else press on any
point of the display (except one of the displayed buttons).
N.B.:
the FSS system activates when the electric pump in the machine's water system starts.
N.B.:
if the FSS system is activated, the relative symbol (3) is displayed in the working screen.
N.B.:
if you want to deactivate the FSS system press button (2) again.
ATTENTION:
before starting any work, remember to start the FSS system.
N.B.:
to return to the working screen press on any point of the screen, except the edges of the display or else wait three seconds without
touching anything.
OFFICE
0000.00
100%
ECO mode
0000.00
100%
1
2
2
1
3
ADJUSTING THE DETERGENT SOLUTION FLOW (PRO VERSION)
To adjust the flow of detergent solution during work, proceed as follows:
1.
During the first few working meters check that the amount of solution is sufficient to wet the floor, but
not excessive to exit the splash guard.
2. If the amount of solution that comes out is not right, use the “+” and “-” buttons (1) on the control
panel to adjust it (
Fig.1
).
N.B.:
The flow of detergent solution on the brush can be adjusted to one of four levels, from 0 to
3. The level can be seen with the symbol (2) on the control display (
Fig.2
).
N.B.:
If the flow is set to 0, there is no emission of detergent solution.
1
1
2
2
33