Filtration Group PiW 2175, Перевод оригинальной инструкции

Страница: 37 / 60

Page 17
Translation of the original instructions PiW 2175, Filtration Group GmbH, 28.06.20, Mat. No. 72348069, Version 04
17 Troubleshooting table
Fault Cause Remedy
Water not separated Volume flow rate too high Reduce the volume flow rate
Fluid not suitable Don't use detergent liquids (water
binding additives)
Viscosity too high Make sure the temperature is suitable
for the fluid
Warning signal from maintenance
indicator
Cold start Reset the signal after reaching
operating temperature
Coalescer element dirty Replace the coalescer element
Water level sensors show incorrect
values
Water level sensors set incorrectly Set the water level sensors correctly
(see plan).
Please contact the manufacturer if the fault still persists after carrying out the corrective measures described above.
18 Spare parts
Part name / DIN designation ID No. Benennung/DIN Bezeichnung
Coalescer element 76361281 Coalescerelement
Seal kit 72348122 Dichtungssatz (inkl. Anzeigedichtungen und
Entlüftungsschraube)
Droplet separator 72356994 Tropfenabscheider
Water level sensor 72348133 Wasserstandsensor
Electrical top part 77536550 El. Oberteil

Use only FG original spare parts!