Fiery X3e 31C-M Color Server, Руководство по управлению заданиями

Страница: 52 / 216

2
2-26 Introduction to Command WorkStation and Command WorkStation LE
4. In the Select Pages area (Command WorkStation) or in the Print Pages dialog box
(Command WorkStation LE), specify the pages you want to print.
Each set of pages contains specific information about the Fiery X3e.
You can print the following pages from the Fiery X3e:
PS Test Page/PCL Test Page
—Allows you to confirm that the Fiery X3e is properly
connected to the copier/printer, and provides color and grayscale samples to
troubleshoot problems with the copier/printer or the Fiery X3e. The following settings
are among those listed on the Test Page: Server Name, Printer Model, color settings,
calibration information, and date and time the Test Page was printed.
Configuration
—Provides the current Fiery X3e and copier/printer configuration. This
page lists general information about the hardware and software configuration of the
Fiery X3e, current settings for all Setup options, information about the current
calibration, and the network addresses of the Fiery X3e.
Job Log
—Lists a log of the last 55 jobs processed or printed. For information on the
fields in the Job Log and printing it in other forms, see “Using the Job Log” on
page 3-30.
Control Panel Map
— Provides an overview of the screens you can access from the
Control Panel. For information on using these screens to set up the Fiery X3e, see the
Configuration Guide .
Color Charts
—Provides samples of the RGB, CMY, and PANTONE colors available
from the Fiery X3e.
PS Font List
—Lists all PostScript fonts currently resident on the Fiery X3e hard disk
drive.
PCL Font List
—Lists all PCL fonts currently resident on the Fiery X3e hard disk drive.
E-mail Log
—Lists a log of the last 55 E-mail printing status reports, information that
can be useful to the network administrator. The reports cover printing or scanning via
the E-mail printing feature, monitoring the address book, and overall transmissions.
You must enable the E-mail printing feature in Setup before the E-mail Log can be
printed.
FTP Log
—Lists a log of the last 55 scanned jobs that have been sent over the network
using the Scan to FTP feature. The FTP scanning feature must be enabled in Setup
before the FTP Log can be printed. For more information, see the
Printing Guide .