Fiery Fiery EX2101, Руководство по управлению заданиями

Страница: 65 / 214

3
3-5 Starting up and logging in
Access levels
The three possible levels of access to Command WorkStation or Command
WorkStation LE are Administrator, Operator, and Guest. To enable maximum
password protection, Administrator and Operator passwords must be specified in
Setup (see the
Configuration Guide ).
When both Administrator and Operator passwords have been specified, the access
levels are as follows:
N
OTE
:
In Command WorkStation, a user can be logged in as Administrator on one
Fiery EX2101, as Operator on a second Fiery EX2101, and as Guest on a third
Fiery EX2101. In these instances, the levels of access are dependent either on the
Fiery EX2101 currently selected in the Active Jobs window or on the Fiery EX2101
that holds the currently selected job.
By default, no passwords are set on the Fiery EX2101—in this default state, anyone
can perform Setup and use all Command WorkStation and Command WorkStation
LE functions. Until an Administrator password is defined in Fiery EX2101 Setup, you
can log in to the Fiery EX2101 as Administrator without entering a password and are
given full privileges.
After the administrator has performed Setup and specified passwords, Command
WorkStation and Command WorkStation LE user options depend on your login level.
This manual assumes that you are logged in to the Fiery EX2101 as Operator.
Access level Privileges and password requirements
Administrator Has full access to all Command WorkStation and Command
WorkStation LE functions, as well as Fiery EX2101 Control Panel
function. Administrator password required. For a description of the full
range of tasks an administrator can implement, see the
Configuration
Guide
.
Operator Has access to all Command WorkStation functions, except Setup, font
management, reordering job priority, restarting the Fiery EX2101,
clearing the Fiery EX2101 hard disk drive, and clearing the Job Log.
Operator password required.
Guest Can view job status, but cannot make changes to jobs or Setup, and
cannot access the Job Log; no password required.