3
3-3
Starting up and logging in
This manual assumes you are logged into the server as an operator. The following
section discusses the three different access levels in greater detail.
Access levels
The three possible levels of access to Command WorkStation functions are
Administrator, Operator, and Guest. To enable maximum password protection,
Administrator and Operator passwords must be specified in Setup (see the
When both Administrator and Operator passwords have been specified, the access
levels are as follows:
N
OTE
:
A user may be logged in as Administrator in one server, as Operator in a second
server, and as Guest in a third server with Command WorkStation. In these instances,
the levels of access are dependent either on the server currently selected in the Active
Jobs window or on the server that holds the currently selected job.
By default, no passwords are set on the Fiery—in this default state, anyone can
perform Setup and use all Command WorkStation functions. Until an Administrator
password is defined in Fiery Setup, you can log in to Command WorkStation as an
administrator without entering a password, and you are given full privileges.
After the administrator has performed Setup and specified passwords, Command
WorkStation user options depend on your login level. This manual assumes that you
are logged in to the server as an operator.
Access level
Privileges and password requirements
Administrator
Has full access to all Command WorkStation and Fiery Control Panel
functions; Administrator password required. For a description of the
full range of tasks an administrator can implement, see the
Operator
Has access to all Command WorkStation functions,
except
Setup, font
management, restarting the server, clearing the server disk, and clearing
the Job Log. Operator password required
Guest
Can view job status, but cannot make changes to jobs or Setup, and
cannot access Job Log; no password required
