Fiery DocuColor 3535, Руководство по настройке

Страница: 57 / 116

4
4-5 Fiery Setup from the Copier Control Panel
TCP/IP–Subnet Mask
DHCP (Address Required)
This option lets you modify the subnet mask for printing with TCP/IP over Ethernet.
To set the subnet mask, enter one of the following values:
•
255.0.0.0
if the IP address starts with a number less than 128
• 255.255.0.0 if the IP address starts with a number from 128 through 191
•
255.255.255.0
if the IP address starts with a number greater than 191
N
OTE
:
Confirm the subnet mask setting with your network administrator before
proceeding. In some cases, the required setting may be different from that listed.
TCP/IP–Gateway Address
DCHP (Address Required)
Use this option to set the gateway address for printing with TCP/IP. If your network
uses a gateway, you must change the default to a correct gateway address for
your network.
When you set an IP address, subnet mask, or gateway address for the Fiery during
Setup, you can allow the Fiery to get these addresses automatically from a DHCP or
BOOTP server. First, turn on or restart the Fiery and allow it to reach Idle. Make sure
the DHCP or BOOTP server is running, and then perform Fiery Setup.
Exit Setup
Choose Save and Exit Setup when you have finished making Setup changes.
The Fiery restarts and any changes you saved during the Setup take effect.