Fiery DocuColor 3535, Руководство по настройке

Страница: 48 / 116

3
3-6 Preparing for Fiery Setup
PrintMe
PrintMe allows users to access and print their e-mail messages, Internet content, and
other documents anytime, anywhere, from any device, to the Fiery.
N
OTE
:
Jobs sent with a PrintMe account are only sent through the Fiery
Direct connection.
For more information about PrintMe, go to www.printme.com.
Control level scenarios
Typical scenarios of access and control, ranging from minimum control to maximum
control, are described in this section. Choose the scenario that best matches your site
requirements, and refer to the corresponding number in the following table for
guidance on how to configure your system for those requirements.
N
OTE
:
We strongly recommend that you set at least an Administrator password to
prevent unauthorized changes to system settings.
1. No designated administrator or operator (Minimum control—not recommended)
All users have equal access to all system functions including Setup, clearing the Fiery,
deleting printer fonts, setting the WebLink address, performing calibration, printing to
all Fiery print connections, and managing all jobs from the job management tools.
2. An administrator but no operator
Only an administrator can perform Setup, calibration, and other administrator
functions, but all other system functions are accessible to all users, including printing
to all Fiery print connections, and managing all jobs from the job management tools.
3. An administrator and an operator
Only an administrator can perform Setup, calibration, and other administrator
functions, and only an operator or administrator can control jobs from the job
management tools. Users can print to all Fiery print connections.