Fiery DocuColor 3535, Руководство по настройке

Страница: 38 / 116

2
2-14 Setting up Network Servers
Tips for experts—NetWare 5.x networks
Setting up the Fiery in an NDPS environment is similar to setting up any other
PostScript printer on the network. When setting up the Fiery in such an environment,
refer to the following information:
• Make sure you have a valid IP address for the Fiery and for any workstations that will
print to it or run Fiery utilities.
• In Fiery Setup, enable TCP/IP and enter the IP address, subnet mask, and gateway
address for the Fiery. You can enter these manually or use DHCP or BOOTP protocols to
assign the addresses dynamically.
• In Fiery Setup, make sure you have enabled LPD printing on the Fiery. You can ping
the Fiery (
page 2-17 ) to verify that TCP/IP communication is successful.
For information about setting up NDPS, see your Novell Netware documentation.
Fiery on a network with UNIX workstations
When a UNIX workstation is configured with the lpd protocol and connected to the
Fiery over a TCP/IP network, it can print directly to the Fiery.
Setting up UNIX workstations requires an administrator with root privileges. After the
initial configuration, UNIX users simply submit print jobs to a named printer.
The job management tools, along with the other Fiery utilities and Fiery WebTools,
are unavailable on the UNIX platform. A Windows or Mac OS computer on the same
network as the UNIX computer that is set up to use TCP/IP for printing to the Fiery
can use the job management tools to manage print jobs that originate from all
workstations on the network.