Fiery DocuColor 3535, Руководство по настройке

Страница: 28 / 116

2
2-4 Setting up Network Servers
Adding the Fiery to the TCP/IP network
If your TCP/IP network consists of Windows NT 4.0/2000 servers, and
Windows NT 4.0/2000/XP clients, follow the procedures in this section. If the
network also includes UNIX workstations, follow the procedures on
page 2-16 .
T
O ADD THE
F
IERY TO A
TCP/IP
NETWORK WITH A
W
INDOWS
NT 4.0/2000
SERVER
1. Register the IP address of the Fiery in the host name database used
by your system.
For installations that do not have a network administrator or central host name
database, add the Fiery to the
hosts file on the Windows NT 4.0/2000 server. Also add
it to the hosts file on any workstations that have TCP/IP loaded and will use the
Fiery utilities.
The Windows NT 4.0/2000 hosts file provides compatibility with the UNIX hosts
file. The hosts file is used as a local Domain Name Services (DNS) equivalent. It has
the same format as the
/etc/hosts
file on UNIX servers. The format of the hosts
entry is:
IP Address<TAB>host name<TAB>#comments
where <TAB> indicates that you press the Tab key.
To determine the IP address and server name of your system, print a Configuration
page (see
page 7-7 ).
N
OTE
:
If the Fiery has already been defined in an
/etc/hosts
file or equivalent host
name database on a UNIX workstation on your network, we recommend that you use
the same host name here as you used for the name of the remote printer in the
/etc/printcap file.
2. Perform Fiery Setup to support TCP/IP printing.
Enter the options in Protocol Setup (IP address of the Fiery, subnet mask, and gateway
address). If you select DHCP/BOOTP, we recommend that you configure the DHCP
server to always supply the same IP address to Fiery
.