Fiery DocuColor 3535, Руководство по настройке

Страница: 23 / 116

1
1-11 Connecting network cable to the Fiery
Ethernet connection
For Ethernet connections, the Fiery supports cabling, defined as Category 5 for use
with 100BaseT; or as Category 3, Category 4, or Category 5 for use with 10BaseT.
The cable uses an 8-pin RJ-45 connector that plugs into the RJ-45 socket on the Fiery.
N
OTE
:
The 100BaseT type supported by the Fiery is 100BaseTX, also known as Fast
Ethernet. If an Ethernet hub is used, it must be a 100BaseTX hub. The term
“100BaseT” is used to refer to 100BaseTX. All connection types are supported in
half-duplex mode.
T
O CONNECT TO THE
E
THERNET BOARD
• Connect the network cable to the RJ-45 connector on the back of the Fiery.
You must use a Category 5 unshielded twisted pair cable network cable for 100BaseT.