Fieldmann FZS 3020-B, Руководство пользователя

Страница: 11 / 24

EN
PETROL BRUSH CUTTER USER'S MANUAL
11
Assembly
Installing the string trimmer head
Lock the shaft in place by inserting the hex key
(see fi g. 6). To achieve this, it is necessary to align
the hole in the protective guard with the hole in
the shaft and insert the hex key. Align the holes by
turning the protective guard.
Install the individual components in the following
order:
1. cogged retaining washer A (also equipped
with a retaining hole)
2. string trimmer head
Please screw the string trimmer head on the shaft
by turning anticlockwise (mind the reverse thread)
and tighten properly.
Take the hex key out of the retaining hole.
Winding string trimmer line on to the
trimmer head
1. Push in the retaining latches on the side of the
head and take off the cover (see fi g. A & B)
2. Take the spool out of the string trimmer head.
Prepare about 2-3 m of string trimmer line with
a diameter of 2.4 mm.
3. Bend the string trimmer line in the middle and
secure the bend in the groove (see fi g. C)
4. Wind both ends in parallel on to the spool in
a clockwise direction. Secure the ends of the
wound on string trimmer line into the prepared
holes (see fi g. D)
5. Return the spool back into the string trimmer
head and secure in place with the cover
(see fi g. E and F)
WARNING!
Use only good quality nylon string trimmer line
with a diameter of 2.4 mm. Never use wire or wire-
reinforced string trimmer line instead of the nylon
string trimmer line. Only use the original string trimmer
head.
B
C
D
E F
A
Fig. 6
Hex key 4 mm
Shaft
Protective cover
Cogged retaining
washer A
Locking hole
String trimmer head
8 8JOEJOHTUSJOHUSJNNFSMJOF
POUIF58*45(0USJNNFSIFBE