background image

Page 3 

P

ROPERLY WRAPPING THE ANTENNAE

 

The antenna wrap around the water pipe on each end of the ClearWave™ (see Figure 1).  A minimum of 
seven fully wrapped coils of the antenna wire, with each coil wrapped tightly against the pipe and pressed 
snugly against each other is required for best results (see Figure 1A). Each wire coil should be spaced I inch 
to 2 inches apart. The operation of the ClearWave™ and the antenna installation is not based on direction of 
water flow, but one antenna MUST be wrapped in a clockwise direction and the other wrapped in an counter- 
clockwise direction. 

1.  On the right side of the unit wrap the first antenna onto the water pipe by securing the “CW” clockwise 

antenna to the water pipe next to the ClearWave™ housing with a wire tie.  Wrap the right antenna 
clockwise (over the top of the pipe first), keeping the antenna wire tight against the pipe and the preceding 
coil.  Secure the end of the antenna wire to the water pipe with a wire tie (see Figure 1A).  Repeat 
wrapping the remainder of the antennas onto the pipe alternating the wrap direction (see Figure 1). 

2.  On left side of the unit wrap the first antenna onto the water pipe by securing the “CCW counter clockwise 

antenna to the water pipe next to the ClearWave™ housing with a wire tie.  Wrap the antenna counter 
clockwise (Under the bottom of the pipe first),  keeping the antenna wire tight against the pipe and the 
preceding coil.  Secure the end of the antenna wire to the water pipe with a wire tie. Repeat wrapping the 
remainder of the antennas onto the pipe alternating the wrap direction (see Figure 1). 

3.  When energized, the ClearWave™ by plugging in the power supply, the modulation indicator lights start 

flashing sequentially indicating that the ClearWave™ is functioning properly.  If the indicator lights do not 
flash sequentially, unplug the power supply, wait one minute then plug in the power supply again.  If at any 
time a functional problem is suspected, unplug the power supply, wait one minute then plug in the power 
supply again. 

 

Figure 1 

 

Figure 2 

 

Figure 1A 

Отзывы: