Fidelity Electronics 19eA, Руководство по эксплуатации

Страница: 44 / 62

44
16.3 Quick Access to Label Settings
If label printer is selected either for Comport 1 or Comport 2, follow the below procedures to access quick label
settings during operation.
a.
Press [Set] .
b.
Instrument displays F1.
c.
Press [Check] , instrument displays number of copy to generate each time. Press [Func] or [Unit] until the
preferred parameter appears then press [Print/M+] to save.
d.
Instrument displays label file number (FL1 01 ~ FL1 99) to print in label format group 1. Press [Func] or
[Unit] until the preferred label file number appears then press [Print/M+] to save.
e.
Instrument displays label file number (FL2 01 ~ FL2 99) to print in label format group 2. Press [Func] or
[Unit] until the preferred label file number appears then press [Print/M+] to save.
f.
At this point, label settings are completed.
16.4 Repetitive Printout
This Instrument supports repetitive printout under Manual print mode. Press [Print/M+] for additional printout copies.
Conditions and criteria as below: -
a.
When Auto Accumulation is set to On: Repetitive print is only possible when the actual weight on scale is equal
to the weight value of the 1
st
printout.
b.
When Auto Accumulation is set to Off: Repetitive print is possible if minimum output weight set is matched and
when
[Print/M+] is pressed.
c.
Weight value of repetitive printout will not change the total accumulation result. Only the weight value of the 1
st
printout will be accumulated to memory.
17. Built-in Battery & Recharging
17.1 Battery Operation Time
Depends on the battery operation condition, a new and fully charged rechargeable battery can provide
57
50~80
operation hours. The following setting helps increasing battery service time: -
•
F8 Brightness: - the brighter the LED indicator, the shorter the battery service time.
•
F31 Auto Power Saving: - always set this to On. This will help save power especially when the instrument
is unattended.
Remaining battery power of the built-in rechargeable battery is displayed by the
Battery Power/Level Indicator.
17.2 Symbols & Remaining Power
When Lo Battery Indicator appears, battery level is low. Apply power adaptor to recharge battery immediately otherwise
instrument will power off automatically shortly.
•
Flashing: - Battery level is low (less than 20%). Apply power adaptor to recharge battery as soon as possible.
•
Lit on: - Battery level is at extreme low (less than 15%)
To protect the built-in rechargeable battery, this instrument will be powered off automatically when battery is at extremely
low level. If this is the case, do not attempt to power this instrument on. Recharge this instrument immediately. Fail to
do so may cause unrecoverable damages to the built-in rechargeable battery.
17.3 Battery Charging Status
Battery charging status is shown on the dual color Charge Status Indicator : -
•
Red: - Recharging in process,
•
Green: - Charging completed.
57
When connect to one 350 ohm load cell.