Operating instructions WPM Gateway IoT
17/76
Commissioning
5
COMMISSIONING
5.1
Initial commissioning
5.1.1
Network settings
As default, the WPM Gateway is preset with the static
IP address 10.10.10.10
. This IP address
can be changed by a network Administrator when integrating the WPM Gateway into the com-
pany IT infrastructure.
To be able to access the WPM Gateway, the PC with which access is to be made must be man-
ually set to a fixed IP address.
The selection of the fixed IP address is at the discretion of the user.
For the following descriptions, the
IP address 10. 10. 10. 100
is used.
1) Open the
control panel
of the PC.
2) Open the
Network and Sharing Center
.
3) Open an Ethernet connection.
4) Open the properties in the selection window
Ethernet Status
.
5) In the selection window
Ethernet Properties
open the Internet Protocol, Version 4 (TCP/
IPv4).
6) In the
Internet Protocol, Version 4 (TCP/IPv4)
selection window, configure the following set-
tings:
•
Use the following IP address
•
IP address 10. 10. 10. 100
•
Subnet mask 255. 255. 255. 0
7) Confirm settings with OK.
