FiberHome AN6000-17, Описание аппаратуры

Страница: 71 / 88

5 Wires and Cables
Table 5-4 Connection of the Optical Fiber Jumper (Continued)
Cable Connector
Card
Connected
Interface
Connected
Connection on the ODF Side
LC/PC
connector
HSCA
SFP+ (1 to 4)
Connected to the IP network to provide the GE,
10 GE and 100 GE optical channels.
KU1A
1, 2 to 5
HU8A 1 to 8
Basis for Choice of Optical Fiber
Parameter Basis for Choice
Length On-site investigation
Single-mode / multi-mode Type of the optical module
Type of the optical fiber connector
u Optical module type
u Cabinet depth
Note 1
u Among the SC/PC optical fiber connectors, the 55 mm long and 39 mm long ones are most commonly used. The
55 mm ones are called long connectors, and the 39 mm ones are called short connectors. When the equipment
is mounted in a 300 mm-deep cabinet, it is advisable to use the 39 mm optical fiber connectors (short
connectors).
u Among the LC/PC optical fiber connectors, the 48 mm long and 31 mm long ones are most commonly used. The
48 mm ones are called long connectors, and the 31 mm ones are called short connectors. When the equipment
is mounted in a 300 mm-deep cabinet, it is advisable to use the 31 mm optical fiber connectors (short
connectors).
5.6 Network Cable
Function
The network cable is used for uplinking via the electrical port or equipment
monitoring via the network management system. It connects the uplink equipment,
the network management computer, or the environment monitoring equipment.
Model
The model number of the straight-through network cable is 3695095.
Structure
Both ends of the network cable are installed with the RJ-45 connectors (also known
as crystal heads), as shown in Figure 5-6.
Version: A 63