FIBER FOX Mini5C, Руководство пользователя

Страница: 30 / 33

- 30 -
Dust Error
(fiber core)
There’s dust or dirt on the fiber
surface
Prepare the fiber again
The lens or LEDs are coated in
dust
Execute the dust check after
cleaning the lenses and LEDs
Cleaning Arc time is too short
Set the cleaning arc time to be
180ms
It is difficult to identify the fiber
core by using the method of core
alignment to splice
It is difficult to identify the fiber
core by using MM splice mode to
splice
There’s dust or dirt on the fiber
surface
Prepare the fiber again
There’s dust or dirt on the fiber
surface
Execute the [Dust check] after the
lenses and LEDs are cleaned
Cleave angle limit is too low
Increase the cleave angle limit to
a decent value
(standard value: 3.0˚c)
Fat Fiber
Overlap too much Adjust overlap parameter
Motor is not calibrated Calibrate and maintain the motor
Thin Fiber
Arc power too low Execute [Arc Calibration]
The level of pre-discharge is too
high
Decreased pre-discharge of
pre-discharge time
Insufficient overlap Adjust overlap parameter