FIBARO HC3L-001, Руководство по эксплуатации

Страница: 22 / 63

22
connectIng WItH eXIstIng Z-Wave netWorK
3. After couple of minutes both controllers will have the same network
information.
Copying information to this controller from the primary controller
1. Start adding procedure on the primary controller (according to its
manual).
2. Go to
> Z-Wave .
3. Under Start Learn Mode click Start
4. After couple of minutes both controllers will have the same network
information.
12.3: DSK AND PIN
In case you need full DSK code of the gateway you will find it on the label
under the device.
If no Z-Wave devices are added to the gateway or the gateway is a
secondary controller (not SIS*), you can also find the full DSK in the
interface:
1. Open the Configuration Interface.
2. Go to
> Z-Wave .
3. Under Start Learn Mode click Start
4. Click in the left sidebar to open the Console, where the DSK will
be displayed.
* SIS – Static Update Controller configured to enable other controllers to
include/exclude nodes on its behalf