Fiat 500L 2018, Руководство пользователя

Страница: 35 / 180

NOTE:
Make sure the garage door opener motor is
plugged in before moving on to the rolling
code/non-rolling code final steps
.
Rolling Code Garage Door Opener Final Steps
NOTE:
You have 30 seconds in which to initiate rolling
code final step 2, after completing rolling code
final step 1
.
1
.
At the garage door opener motor (in the
garage), locate the “LEARN” or “TRAIN”
button
. This can usually be found where the
hanging antenna wire is attached to the garage
door opener motor
. Firmly push and release
the “LEARN” or “TRAIN” button
.
2
.
Return to the vehicle and push the pro-
grammed HomeLink button three times
(holding the button for two seconds each
time)
.
If the garage door opener motor oper-
ates, programming is complete .
3 . Push the programmed HomeLink button to
confirm that the garage door opener motor
operates
.
If the garage door opener motor
does not operate, repeat the final steps for the
rolling code procedure
.
Non-Rolling Code Garage Door Opener Final
Steps
1
.
Push and hold the programmed HomeLink
button and observe the HomeLink indicator
light
.
If the HomeLink indicator light stays on
constantly, programming is complete .
2
.
Push the programmed HomeLink button to
confirm that the garage door opener motor
operates
.
If the garage door opener motor
does not operate, repeat the steps from the
beginning
.
WARNING!
• Your motorized door or gate will open and
close while you are programming the uni-
versal transceiver
. Do not program the
transceiver if people or pets are in the path
of the door or gate
.
• Do not run your vehicle in a closed garage
or confined area while programming the
transceiver
. Exhaust gas from your vehicle
contains Carbon Monoxide (CO) which is
odorless and colorless
. Carbon Monoxide is
poisonous when inhaled and can cause you
and others to be severely injured or killed
.
Programming HomeLink To A Miscellaneous
Device
Refer to “Programming HomeLink To A Garage
Door Opener” for the procedure on how to
program HomeLink to a miscellaneous device, as
it follows the same procedure
.
Be sure to deter-
mine if the device has a rolling code, or non-rolling
code before beginning the programming process
.
NOTE:
Canadian radio frequency laws require transmit-
ter signals to time-out (or quit) after several
seconds of transmission, which may not be long
enough for HomeLink to pick up the signal during
programming
. Similar to this Canadian law, some
U
.
S
.
gate operators are designed to time-out in
the same manner
.
The procedure may need to be
preformed multiple times to successfully pair the
device to your HomeLink buttons
.
Reprogramming A Single HomeLink Button
To reprogram a single HomeLink button that has
been previously trained, without erasing all the
channels, follow the procedure below
.
Be sure to
determine whether the new device you want to
program the HomeLink button to has a Rolling
Code, or Non-rolling Code
.
33