Fiat 500L 2018, Руководство пользователя

Страница: 34 / 180

Ensure that your vehicle is parked outside of the
garage before you begin programming
.
It is recommended that you erase all the channels
of your HomeLink before you use it for the first
time
.
If you have any problems, or require assistance,
please call toll-free 1-800-355-3515 or, on the
Internet at HomeLink
. com for information or
assistance
.
Erasing All The HomeLink Channels
To erase the channels, follow this procedure:
1
.
Place the ignition switch into the ON/RUN
position
.
2
.
Push and hold the two outside HomeLink
buttons (I and III) for up to 20 seconds, or until
the HomeLink indicator light flashes
.
NOTE:
Erasing all channels should only be performed
when programming HomeLink for the first time
.
Do not erase channels when programming addi-
tional buttons
.
Identifying Whether You Have A Rolling Code
Or Non-Rolling Code Device
Before programming a device to one of your
HomeLink buttons, you must determine whether
the device has a rolling code or non-rolling code
.
Rolling Code Devices
To determine if your device has a rolling code, a
good indicator is its manufacturing date
. Typically,
devices manufactured after 1995 have rolling
codes
. A device with a rolling code will also have
a “LEARN” or “TRAIN” button located where
the antenna is attached to the device
. The button
may not be immediately visible when looking at
the device
. The name and color of the button
may vary slightly by manufacturer .
NOTE:
The “LEARN” or “TRAIN” button is not the
button you normally use to operate the device
.
Non-rolling Code Devices
Most devices manufactured before 1995 will not
have a rolling code
. These devices will also not
have a “LEARN” or “TRAIN” button
.
Programming HomeLink To A Garage Door
Opener
To program any of the HomeLink buttons to
activate your garage door opener motor, follow
the steps below:
NOTE:
All HomeLink buttons are programmed using this
procedure
. You do not need to erase all channels
when programming additional buttons
.
1 . Place the ignition switch into the ON/RUN
position
.
2 . Place the garage door opener transmitter 1 to
3 inches (3 to 8 cm) away from the HomeLink
button you wish to program, while keeping the
HomeLink indicator light in view
.
3
.
Push and hold the HomeLink button you want
to program while you push and hold the
garage door opener transmitter button you
are trying to replicate
.
4
.
Continue to hold both buttons and observe
the HomeLink indicator light
. The HomeLink
indicator light will flash slowly and then rapidly
.
Once this happens, release both buttons .
GETTING
T
O
KNO
W
Y
OUR
VEHICLE
32