Fiat 500L 2018, Руководство пользователя

Страница: 33 / 180

WARNING!
• Driving with the liftgate open can allow
poisonous exhaust gases into your vehicle .
You and your passengers could be injured by
these fumes
. Keep the liftgate closed when
you are operating the vehicle .
• If you are required to drive with the liftgate
open, make sure that all windows are closed,
and the climate control blower switch is set
at high speed
. Do not use the recirculation
mode .
Gas props support the liftgate in the open
position
. However, because the gas pressure
drops with temperature, it may be necessary to
assist the props when opening the liftgate in cold
weather
.
Liftgate Emergency Release
As a security measure, a liftgate emergency
release is built into the liftgate latching mecha-
nism
. To access the liftgate emergency release,
proceed as follows:
1
.
Remove the rear headrests and fold down the
seats completely
.
2
.
Take the screwdriver from the tool box
supplied
.
3
.
With the screwdriver, remove the yellow tab
.
4 . Press the screwdriver into the seat in order to
trigger the release trunk tab (follow the
direction arrow to open)
.
UNIVERSAL GARAGE DOOR
OPENER (HOMELINK)
• HomeLink replaces up to three hand-held trans-
mitters that operate devices such as garage
door openers, motorized gates, lighting or home
security systems
. The HomeLink unit is powered
by your vehicles 12 Volt battery .
• The HomeLink buttons that are located in the
overhead console or sunvisor designate the
three different HomeLink channels
.
• To operate HomeLink, push and release any of
the programmed HomeLink buttons . These
buttons will activate the devices they are pro-
grammed to with each press of the correspond-
ing HomeLink button
.
• The HomeLink indicator light is located above
the center button .
Before You Begin Programming HomeLink
For efficient programming and accurate transmis-
sion of the radio-frequency signal, it is recom-
mended that a new battery be placed in the
hand-held transmitter of the device that is being
programmed to the HomeLink system
. Make sure
your hand-held transmitter is programmed to
activate the device you are trying to program
your HomeLink button to
.
HomeLink Buttons
31