Fiat 500L 2015, Руководство пользователя

Страница: 27 / 148

ENGINE BREAK-IN RECOMMENDATIONS
A long break-in period is not required for the engine and drivetrain (transmission and
axle) in your vehicle
.
Drive moderately during the first 300 miles (500 km)
.
After the initial 60 miles (100 km),
speeds up to 50 or 55 mph (80 or 90 km/h) are desirable .
While cruising, brief full-throttle acceleration within the limits of local traffic laws contrib-
utes to a good break-in
. Wide-open throttle acceleration in low gear can be detrimental
and should be avoided .
The engine oil installed in the engine at the factory is a high-quality energy conserving
type lubricant
.
Oil changes should be consistent with anticipated climate conditions under
which vehicle operations will occur
.
Refer to “Maintaining Your Vehicle,” for the recom-
mended viscosity and quality grades .
NOTE:
A new engine may consume some oil during its first few thousand miles (kilometers) of
operation
. This should be considered a normal part of the break-in and not interpreted
as an indication of an engine problem or malfunction .
CAUTION!
Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may
result
.
TURN SIGNAL/LIGHTS/HIGH BEAM LEVER
Turn Signal/Lane Change Assist
• Tap the lever up or down once and the
turn signal (right or left) will flash three
times to indicate a lane change and auto-
matically turn off
.
Headlights/Parking Lights
• Rotate the end of the lever to the first
detent for parking lights and headlight
operation
.
NOTE:
The ignition switch must be in the ON/RUN
position for the headlights to operate
.
Turn Signal/Lights Lever
OPERATING YOUR VEHICLE
25