LIGHTS
Multifunction Lever
The multifunction lever, located on the left side of the steering wheel, controls the opera-
tion of the headlights, headlight beam selection, passing light and turn signals
.
NOTE:
The headlights can only be turned on with the ignition in the ON/RUN position
.
Headlights
Rotate the end of the multifunction lever
upward to the first detent for headlight
operation
.
NOTE:
When the headlights are turned on, the
Daytime Running Lights will be deactivated
.
High Beams
With the low beams activated, push the
multifunction lever towards the instrument
panel to turn on the high beams
.
Pull the multifunction lever toward the steering wheel
to turn off the high beams
.
Flash-To-Pass
You can signal another vehicle with your headlights by partially pulling the multifunction
lever toward the steering wheel
.
This will cause the high beam headlights to turn on until
the lever is released
.
Parking Lights
To turn on the parking lights, remove the key or turn the ignition to OFF/LOCK position
and turn on the headlights
.
Daytime Running Lights
To activate the Daytime Running Lights (DRL), rotate the end of the multifunction lever
to the
O
symbol
.
NOTE:
The low beams and side/taillights will not be on with DRL
.
If allowed by law in the country in which the vehicle was purchased the DRL function
can be turned on or off using the display menus
.
Refer to “Uconnect Settings” in “Under-
standing Your Instrument Panel” in your Owner’s Manual at
www
com/en/owners/manuals for further information
.
Turn Signal/Lights Lever
OPERATING YOUR VEHICLE
65
Содержание 500e 2017
Страница 162: ...NOTES 160...