
Locating Tether Anchorages
In addition, there are tether strap anchorages
behind each rear seating position lo-
cated on the back of the seat
.
Center Seat LATCH
WARNING!
This vehicle does not have a center seating position
.
Do not use the center lower
LATCH anchorages to install a child seat in the center of the back seat
.
Installing The Child Restraint Using The LATCH Lower Anchors
NOTE:
Never “share” a LATCH anchorage with two or more child restraints
.
1
.
Loosen the adjusters on the lower straps and on the tether strap of the child seat so
that you can more easily attach the hooks or connectors to the vehicle anchorages
.
2
.
Attach the lower hooks or connectors of the child restraint to the lower anchorages
in the selected seating position
.
3
.
If the child restraint has a tether strap, connect it to the top tether anchorage
.
See
below for directions to attach a tether anchor
.
4
.
Tighten all of the straps as you push the child restraint rearward and downward into
the seat
.
Remove slack in the straps according to the child restraint manufacturer’s
instructions
.
5
.
Test that the child restraint is installed tightly by pulling back and forth on the child
seat at the belt path
.
It should not move more than 1 inch (25
.
4 mm) in any direc-
tion
.
Tether Anchors
GETTING STARTED
29