Festool MFK 700 EQ, Инструкция по эксплуатации

Страница: 17 / 87

6 Commissioning
WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
CAUTION
Heating of the Plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
Connecting and detaching the mains power ca­
ble - see Fig. [2].
6.1
Switching on/off
The switch [3-2] serves as an on/off switch (I =
ON, 0 = OFF).
7 Settings
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1 Electronics
Constant speed
The preselected motor speed is kept constant
through electronic control. This ensures a uni­
form speed even when under load.
Speed control
You can use the adjusting wheel [3-1] to contin­
uously adjust the speed within the speed range
(see Section Technical data). This enables you
to optimise the speed to suit the respective ma­
terial. Please also note the specifications on the
tools.
Scorch or melt marks on the material can be
prevented through reducing the speed.
Temperature cut-out
The power supply is restricted and the speed
reduced if the motor exceeds a certain temper­
ature. The power tool continues operating at re­
duced power to allow the ventilator to cool the
motor quickly. The power tool starts up again
automatically once the motor has cooled suffi­
ciently.
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically
if the power is disconnected when the on/off
switch is pressed. In this case, the power tool
must be switched off and then switched back on
again.
Due to the built-in restart protection, the power
tool cannot be switched on and off via an exter­
nal switch module.
7.2
Replacing router table
The large surface router table is already fitted
as standard. The large contact surface and pre­
cision adjustment features of this router table
enable a high degree of accuracy. Other router
tables are included in the accessories pro­
gramme.
a) Large surface router table
► Slide the router table onto the retaining pin
on the machine.
► Tighten the screw [4-1] to clamp the router
table in position.
► Place the extraction hood [4-2] in position.
► Tighten the screw [4-3] to clamp the ex­
traction hood in position.
► Place the extractor connector [4-4] on the
extraction hood.
Removal in reverse order.
b) Router table for edge veneer
The "router table for edge veneer" (only in SET
scope of delivery) is designed for flush trim­
ming veneer overhang and profile routing.
The router table is tilted 1.5° so that the
surface coating is not damaged during
edge routing. A router table with 0° incli­
nation angle for precise cuts is available
as an accessory.
► Secure the sensor [5-1] to the machine us­
ing the preassembled screws. Slide the
sensor in the long holes to adjust the rout­
ing tool to the perfect position.
► Slide the router table onto the retaining pin
on the machine.
► Tighten the screw [5-2] to clamp the router
table in position.
► Place the extraction hood [5-3] in position.
English
17