YXML
Linear gantry
Festo SE & Co. KG
Ruiter Straße 82
73734 Esslingen
Deutschland
+49 711 347-0
www.festo.com
Operating instructions
8170140
2022-03a
[8170142]
Translation of the original instructions
© 2022 all rights reserved to Festo SE & Co. KG
1
About this document
1.1
Applicable documents
All available documents for the product
The area of application and the approvals of the individual components of the kit
are described in separate documents
Download configuration-dependent documents
The technical data for the product are described in configuration-dependent docu-
ments.
These documents form part of the product documentation and can be down-
loaded as follows.
1. Read the order ID of the product.
2. Download the documents from the Festo Support Portal by entering the order
ID
3. Print out the documents and keep them together with these operating
instructions.
2
Safety
2.1
General safety instructions
–
Only use the product in its original condition without unauthorised modifica-
tions.
–
Only use the product if it is in perfect technical condition.
–
Observe labelling on the product.
–
Before working on the product, switch off the power supply and secure it
against being switched on again.
–
Observe tightening torques. Unless otherwise specified, the tolerance is
± 20 %.
2.2
Intended use
The intended use of the product is to execute positioning tasks within machines
or automation systems with a higher-order controller in an industrial environment.
2.3
Foreseeable misuse
Never use the product as follows:
–
With unauthorised modifications or alterations to the product
–
With load limits exceeded
–
In an invalid mounting position
3
Additional information
–
Contact the regional Festo contact if you have technical problems
–
Accessories and spare parts
4
Product overview
Linear gantry
YZ module type
YXML-1
EXCT-15
YXML-2
EXCT-30
YXML-3
EXCT-100
Tab. 1: Product allocation
Product labelling
In addition to product labelling of individual components, the product also has
configuration-specific, higher-order product labelling in accordance with the fol-
lowing schematic:
4
1
2
3
Fig. 1: Configuration-specific product labelling
1
Product name
2
Configuration-specific order ID
3
Festo serial number
4
Configuration-specific
Product Key
The configuration-specific, higher-order product labelling is attached to all prod-
ucts at a specifically defined position.
1
Fig. 2: Position of higher-order product labelling
1
Position of higher-order product
labelling
5
Assembly
5.1
Demounting/mounting motors
DANGER
Serious injuries due to the motor falling from an elevated position.
• Demount motors with brake before assembling the product.
• Before loosening the retaining screws: secure the motor against falling.
WARNING
Electric shock.
• Make sure that the motors are disconnected from the power supply.
NOTICE
Third-party motors with a driving torque that is too high can damage the product.
• When using third-party motors observe the following:
• Only use motors with a brake.
• Maximum approved driving torque
• Attachment dimensions motor interface
• Matching combination of coupling, coupling housing and motor flange
