37 / 52
Festo 7EXCMc_en
4. Release the threaded pin in the coupling.
5. Remove the coupling from the motor shaft.
4.2.3.2
Mounting the motor / coupling
1. Push the coupling onto the motor shaft until the distance between the
motor and coupling is X = 4
±0.1
mm.
2. Tighten the threaded pin to the appropriate tightening torque.
Type
Tightening torque
Coupling, EAMC-14-22-5-5
0.37 Nm ± 20 %
Coupling, EAMC-B-15-22-5-5
1.5 Nm ± 20 %
X
Note
When attaching the motor, ensure that the coupling does not tilt with the
pinion shaft. Therefore, the motor must be positioned on the motor pulley
housing at a 90° angle.
3. Turn the motor shaft so that the threaded pin of the coupling is aligned with
the drill hole in the motor pulley housing.
4. Insert the motor carefully according to the motor mounting variant
(
5. Push the motor onto the motor pulley housing and tighten the threaded
pins of the motor clamp to a tightening torque of 1.2 Nm ±10 %.
6. Tighten the threaded pin of the coupling to the appropriate tightening
torque.
Type
Tightening torque
Coupling, EAMC-14-22-5-5
0.37 Nm ± 20 %
Coupling, EAMC-B-15-22-5-5
1.5 Nm ± 20 %
Содержание EXCM-10
