Festo CPX-FB37, Перевод оригинальной инструкции

Страница: 37 / 88

4 Commissioning
Festo – P.BE-CPX-FB37-EN – 1406NH – English 37
4.6 Parameterisation
4.6.1 Introduction to parameterisation
The system reaction of a CPX terminal can be largely adapted to the relevant application. You can indi-
vidually set the reaction of the entire terminal as well as of individual modules and channels through
parameterisation. A distinction is made between the following parameterisation functions:
– System parameterisation, e.g. switching off fault messages, setting reaction times
– Module parameterisation (module- and channel-specific), e.g. monitoring functions, settings for
error handling, settings for forcing
– Parameterisation of the diagnostic memory.
General information on commissioning the CPX terminal as well as a detailed description
of individual parameters can be found in the CPX system description
(P.BE-CPX-SYS-…).
Information on commissioning the pneumatic interfaces and the digital I/O modules can
be found in the description P.BE-CPX-EA-....
Information on commissioning the analogue I/O modules can be found in the description
P.BE-CPX-AX-....
Instructions on commissioning the pneumatic components can be found in the corres-
ponding description of pneumatics.
Caution
Changes in parameterisation or application-specific parameter settings result in
changes to the module or system behaviour.
• Check especially when replacing CPX terminals to see which settings are necessary
and make sure that these are restored, if necessary (e.g. in the commissioning
phase by appropriate system-start parameterisation).
Warning
Danger of injury to people, damage to the machine and system resulting from uncon-
trolled movements of the actuators and undefined switching states
• During the parameterisation process make sure that nobody is within the sphere of
influence of moving parts of your system.
• It is imperative that you observe the instructions on “Force”, “Idle mode” and “Fail
safe” in the CPX system description (P.BE-CPX-SYS-…), as well as in the description
of the CPX-MMI and in the online help of the CPX-FMT.
The CPX terminal is supplied from the factory with preset parameters. These parameters
are saved in the bus node.
A CPX terminal can only be parameterised if the function “System start with default para-
meterisation and current CPX expansion” is activated (set the “System start” system
parameter accordingly).