Festo CPX-FB33, Руководство по эксплуатации, Страница: 5 / 40

Festo — CPX(-M)-FB33/34/35/43/44/45 — 2022-05f
Product overview
5
2.2 Intended use
The bus node is intended for operation as a station (IO Device) in the Industrial Ethernet system
PROFINET IO.
When the additional Message Queuing Telemetry Transport (MQTT) function is activated, the bus node
can be used as a gateway between Industrial Ethernet networks and an on-premise MQTT broker.
The product may only be used in combination with the CPX Terminal in an industrial environment.
2.3 Training of qualified personnel
This description is intended exclusively for technicians trained in control and automation technology,
who have experience in installation, commissioning, programming and diagnostics of programmable
logic controllers (PLC) and fieldbus systems.
3 Additional information
–
Contact the regional Festo contact if you have technical problems è www.festo.com.
–
Accessories and spare parts è www.festo.com/catalogue.
4 Product overview
4.1 Function
The bus node as a device in a PROFINET IO network establishes the connection to the higher-order
controller. The PROFINET communicates in real-time with the Real-Time Protocol (RT) or the Isochro-
nous Real-Time Protocol (IRT). The switch integrated in the bus node enables division of the network
into several segments. The number of segments in the network can be increased with the use of
additional switches and routers.
The bus node can be used in two different operating modes:
–
Remote I/O
–
Remote controller
Particular functions are only available from a specific revision
è
4.2.2 Product variants.
Priority start-up (Fast Start-up)
The Prioritised Start-up function is also referred to as "fast start-up" or "fast restart" and ensures a
fast start-up of the CPX terminal.
Requirements for using the function Fast Start-up:
–
Intermediate switches and routers must must also support the Fast Start-up function.
Fast Start-up can be combined with the Remote I/O operating mode.
Deactivation of the crossover function speeds up the Fast Start-up function.
The Fast Start-up function is switched over in the control software at two configuration levels:
–
Basic hardware configuration in the properties for the CPX terminal
–
CPX terminal configuration with allocation of the configuration table