ferroamp EnergyHub XL Single 21 kW, Руководство по установке

Страница: 18 / 20

16
2.9 Ethernet connection
To enable data reporting and software updates in EnergyHub, a
working connection to the Internet is required, either via Ethernet
or via USB modem.
Connect a network cable to the display port's network port.
If you are using a 4G USB modem, connect it to the USB port next
to the network port on the display device (only 4G USB modems
provided by Ferroamp are supported). Make sure the coverage for
the 4G modem is adequate.
The following requirements apply to the Internet connection:
•
IPv4 address as well as functioning DNS server and NTP
server are assigned using DHCP.
•
Outgoing traffic to the internet must work properly.
Information on specific ports and more details can be
found at www.ferroamp.com in the FAQ page.
2.10 Mounting of front cover
NOTE! Ferroamp recommends that you proceed with the
commissioning before attaching the front cover. This way you will
have easier access when troubleshooting and resetting the
EnergyHub.
1. Slide on the front cover from the front with top and bottom
aligned to the wall cabinet.
2. Attach the top mushroom screws on both sides of the cabinet.
3. Attach the bottom mushroom screws on both sides of the
cabinet.