Not for
Reproduction
15
remove the retainer hardware and tilt the floor pan up and
then remove from the machine. Reverse the process for re-
installation.
Transmission Release Levers:
Icon
Control Name
Transmission Release Levers
Each transmission is equipped with a transmission release
lever. These levers deactivate the transmissions so that the
unit can be pushed by hand. Both transmission release levers
must be in the same position whether you are driving the
unit or pushing it by hand. See
Pushing the Unit by Hand
for
operational information and control location.
Transmission Oil Fill:
Transmission oil is added through the
hydraulic oil tanks. It also serves as extra holding capacity
for oil as the transmissions heat up and the hydraulic oil
expands. See
Check / Fill Transmission Oil
for oil level check
and fill procedures.
Instrument Control Panel
8
Callout
Control Name
A
Choke
B
PTO Switch
C
Ignition Switch
D
Throttle Control
E
Hour Meter
Choke:
Close the choke for cold starting. Open the
choke once the engine starts. A warm engine may not require
choking. Pull the knob UP to close the choke. Push the knob
DOWN to open the choke.
PTO (Power Take Off) Switch:
The PTO switch
engages and disengages the mower blades. Pull UP on the
switch to engage, and push DOWN to disengage.
Ignition Switch:
The ignition switch starts and stops the
engine, it has three positions:
OFF
Stops the engine and shuts off the electrical
system.
RUN
Allows the engine to run and powers the
electrical system.
START Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN position
with the engine stopped—this drains the battery.
Throttle Control:
The throttle controls engine speed. Move
the throttle forward to increase engine speed and back to
decrease engine speed. Always operate at FULL throttle
when mowing.
Fast throttle speed.
Slow throttle speed.
Hour Meter:
This unit is equipped with a dual function hour
meter that records the number of hours that the engine has
run and the number of hours that the PTO switch has been
engaged.
"A" - Hour Glass Icon
- The hour glass icon flashes when
the hour meter is recording the passage of time.
"B" - Mode Icon
- The mode icon will display an "E" when
displaying engine hours, and a "P" when displaying PTO
hours.
"C" - Time Display
- This is the number of hours that are
recorded.
The default display of the hour meter is engine hours. The
mode icon will display a "E" and the hour glass icon will not
flash.
Содержание ISX800Z Series
Страница 1: ...N o t f o r R e p r o d u c t i o n...
Страница 30: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 31: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 32: ...N o t f o r R e p r o d u c t i o n...
