Not for
Reproduction
40
2. To check the inner lift rod (A, Figure 51) timing, measure
and record the distance between the inner lift pivots (B)
and the inner rod pivots (C). Repeat for the other side of
unit.
51
3. To check the outer lift rod (D) timing, measure and record
the distance between the outer lift pivots (E) and the outer
rod pivots (F). Repeat for other side of unit.
4. If the measurements for the inner rods are equal, and
the measurements for the outer rods are equal, no
further adjustment is required. If the measurements are
NOT equal (greater than 1/8” (3,17 mm) difference),
adjustment is required, continue with
Adjusting the Deck
Lift Rod Timing
.
Adjusting the Deck Lift Rod Timing
1. Lock the deck lift pedal in the 5” (12,7cm) position.
Remove the height adjustment pin (A, Figure 52) and
lower the mower deck.
52
2. To ensure that the deck is in the lowest position, push the
pedal by hand towards the rear of the unit and install the
height adjustment pin in the 3” (7.6 cm) position to hold in
place.
3. Block up the mower deck until all hanger chains are
slack.
4. To adjust the inner lift rod (A, Figure 53): Loosen the
jam nut (B) on the front ball joint (C) then remove the
1/2” hardware (D) fastening the ball joint to the lift
pivot arm. Turn the ball joint
clockwise
to shorten the
distance between the rod pivots or
counter-clockwise
to
lengthen the distance between the rod pivots. Reinstall
the ball joint on the lift pivot arm and secure with the
1/2” hardware previously removed. Tighten the jam nut
against the lift rod.
53
5. To adjust the outer lift rod (E): Loosen the jam nut (F) on
the front ball joint (G) then remove the 1/2” hardware (H)
fastening the ball joint to the lift pivot arm. Turn the ball
joint
clockwise
to shorten the distance between the rod
pivots or
counter-clockwise
to lengthen the distance
between the rod pivots. Reinstall the ball joint on the lift
pivot arm and secure with the 1/2” hardware previously
removed. Tighten the jam nut against the lift rod.
6. Remove blocks from under the mower deck.
7. Remove the cutting height adjustment pin from in front
of the deck lift pedal arm. Lift mower deck and reinstall
adjustment pin in desired mowing height.
Deck Leveling Adjustment
Before adjusting the deck level, the deck lift rod timing must
be checked and/or adjusted.
Содержание 5901879
